spindle-laser-mount-clamp

Spindle Laser Mount Clamp

1 review

This handy spindle clamp-on makes adding your laser quick and easy, and it works perfectly with the AutoDustBoot—just pop off the lower dust shoe and you’re good to go. The mounting holes match those on your original CNC accessories mount.

$25.00

Adding a laser

Clamp it on, and keep your dust boot

A clamp-on spindle mount for a laser. It clamps to the spindle rather than replacing anything, so adding or removing the laser is a short job — and it is designed around the AutoDustBoot, so you pop the lower dust shoe off and the laser has its space.

  • Clamps onto the spindle — nothing permanent
  • Works with the AutoDustBoot fitted
  • Remove the lower dust shoe and the laser clears

Fitting

The holes already line up

The mounting holes match the pattern on the original CNC accessories mount, so it goes on with the hardware and holes you already have.

  • Hole pattern matches the original accessories mount
  • Choose Onefinity or AltMill at checkout

At a glance

MountsA laser, to the spindle
MachineOnefinity or AltMill — chosen at checkout
FittingClamps on; hole pattern matches the original accessories mount
With a dust bootWorks alongside the AutoDustBoot — remove the lower dust shoe

Questions

Do I have to take the AutoDustBoot off?

Only the lower dust shoe, which pops off. The boot itself stays where it is.

Will it fit my existing mount holes?

Yes — the pattern matches the original CNC accessories mount.

Reviews

  1. Jerome Koetter

    Altmill laser mount

    I purchased the digital file from you but it is to small if I could get outside dia I could scale it to size

Write a review
Not published. Used to confirm a purchase.

Show it fitted to your machine if you can. Anything you attach appears with your review once we have read it.