Replacement Brush for AutoDustBoot
Replacement brush for AutoDustBoot
Consumable
A fresh brush, and it seals again
The brush is the part of a dust boot that wears out. When the bristles splay or pack down, the shoe stops sealing against the work and dust starts escaping at the cutter. This is the replacement — pick your machine and brush height at checkout.
- Choose Onefinity or AltMill
- Choose a 1" or 1.5" brush height
- Restores the seal without replacing the whole shoe
At a glance
| Fits | AutoDustBoot dust shoe |
|---|---|
| Machine | Onefinity or AltMill — chosen at checkout |
| Brush height | 1" or 1.5" — chosen at checkout |
| Sold as | A single replacement brush |
Questions
Which height should I choose?
1" is the standard height that ships with the v2 boot. The 1.5" brush gives more travel for an uneven surface or a taller workholding setup.
When should I replace it?
When the bristles have packed down or splayed enough that the shoe no longer touches the work all the way round — that is when dust starts getting past.
Reviews
No reviews yet.