nc3DAir

A wireless converter for the TR-3C style USB-C 3D touch probe. It plugs into the probe's USB-C socket and powers it from a rechargeable battery, so the probe can live in your tool rack and the tool changer can load it like any bit. Every touch reaches the controller in about 4 ms, and if the link drops it reads as touched, so the machine stops instead of crashing.

The 3D touch probe is not included. This is for a TR-3C style USB-C probe you already own.

Needs the ncSender Wireless Receiver, sold separately below. It's the same receiver AutoZeroAir uses. It works with most CNC controllers, as long as the controller has a probe or tool setter input and can supply 5 to 24 V to the receiver.

Orders outside the USA ship without the battery. Lithium cells can't travel that route, so you fit one locally: a 3.7 V 300 mAh LiPo (size 372527). YDL Battery sells the right one. The link opens with YDL's default options, which won't fit. Change them to these before you order:

  • Connector: Molex 1.25-2P 51021-0200
  • Polarity: Standard (metal side facing you, contacts up, wires down: red left, black right)
  • Wire length: 50 mm
  • NTC: No NTC (standard)

$99.00

Pre-order. Pre-orders are open for the first batch. Expected December 2026. Your card is charged when you order.

Add to your order
ncSender Wireless Receiver

See it in action

The full 1000-touch test data is on the nc3DAir page.

Specifications

In the box

Transmitter nc3DAir board in a two-piece clamp housing, with 4 screws
Battery 3.7 V 300 mAh LiPoUS orders only. International orders ship without it
Not included 3D touch probe and receiverThe ncSender Wireless Receiver is sold separately

Compatibility

Probe TR-3C style 3D touch probe with a USB-C socket
Probe connection USB-C plug, 5 V probe supply
Receiver ncSender Wireless ReceiverThe same one AutoZeroAir uses
Controller Any with a probe or tool setter (TLS) inputMust supply 5 to 24 V to the receiver

Performance

Link 2.4 GHz direct, no Wi-Fi needed
Latency 3.6 ms median, 95% under 16 msTouch to controller
Repeatability About 2 µm (1σ)1000-touch test, prototype boards
Fail-safe A lost link reads as touchedThe controller stops the move

Power

Battery 3.7 V 300 mAh LiPo, size 372527Molex 1.25 mm 2-pin connector, 50 mm leads
Charging USB-C
Standby Sleeps in the tool rack, wakes on motion

Software

Updates Over the air from ncSender

Reviews

No reviews yet.

Write a review
Not published. Used to confirm a purchase.

Show it fitted to your machine if you can. Anything you attach appears with your review once we have read it.